Products
Mixer-grinder motor stampings
Alpine Electrotech makes universal-motor stampings for mixer-grinders in CRNO and CRCA, on tungsten carbide tooling, at its works in Daman, India.
Specification
- Grades
- CRNO, CRCACRNO: Non-oriented electrical steel for rotating machines. CRCA: Cold-rolled close-annealed steel for non-electrical parts of an assembly.
- Thicknesses
- 0.50 mm
- Coatings
- C3
- Sold by
- By the set
The thicknesses and coatings available for a given part depend on the grade. We confirm availability for your part at enquiry.
How it is made
Coil is slit in house to the width the tool needs, from mother coil up to 1250 mm wide, and the slit edge is checked for burr before the strip is released to the press floor.
Alpine Electrotech stamps on progressive tooling on power presses from 10 T to 220 T, using auto-stack and auto-skew tooling where the part calls for it. Tools are built from tungsten carbide or high-speed steel to suit the part.
Where a part is not already tooled, the tool layout and the tool cost are quoted alongside the part rate, and the tool cost is amortised transparently in the costing. That is set out under tooling, jobwork and how a new part starts.
The whole run, from material selection to packing, is set out under how a coil becomes a packed lot.
Which markets take it
- Mixer-grinder motors
Universal-motor stampings on tungsten carbide tooling, across the standard design range.
Inspection and documents
Common questions
- What kind of tooling do you build?
- Alpine Electrotech builds progressive tooling, including auto-stack and auto-skew, from either tungsten carbide or high-speed steel to suit the part. Tools are built to Alpine's own standards by long-standing, dedicated toolmakers, and are maintained on the same floor that runs them, so a worn tool is sharpened in house on Alpine's own grinders.
- How is tooling handled, and how is it paid for?
- Alpine Electrotech both builds its own tooling and runs customer-supplied tooling for jobwork; how a tool is handled is agreed per part. Where we build the tool, its cost is amortised transparently in the costing. The tool layout and the tool cost are quoted alongside the part rate, so you see both before you commit.
- How long does it take to get samples?
- Samples from Alpine Electrotech are typically ready 60-90 days from receipt of the drawing and order confirmation. The part is released to run only after first-off inspection against the agreed tolerances.
- What tolerances do you hold?
- Alpine Electrotech agrees tolerances per part against your drawing and confirms them at first-off inspection. We do not publish a blanket tolerance, because the figure that matters is the one on your drawing.