Skip to content

Products

Pump and fan motor laminations

Alpine Electrotech makes stator and rotor lamination sets for pump and fan motors in CRNO, in volume, on progressive tooling at its works in Daman, India.

Specification

Grades
CRNOCRNO: Non-oriented electrical steel for rotating machines.
Thicknesses
0.50 mm to 0.65 mm
Coatings
C3, C5
Sold by
By the set

The thicknesses and coatings available for a given part depend on the grade. We confirm availability for your part at enquiry.

How it is made

Coil is slit in house to the width the tool needs, from mother coil up to 1250 mm wide, and the slit edge is checked for burr before the strip is released to the press floor.

Alpine Electrotech stamps on progressive tooling on power presses from 10 T to 220 T, using auto-stack and auto-skew tooling where the part calls for it. Tools are built from tungsten carbide or high-speed steel to suit the part.

Where a part is not already tooled, the tool layout and the tool cost are quoted alongside the part rate, and the tool cost is amortised transparently in the costing. That is set out under tooling, jobwork and how a new part starts.

The whole run, from material selection to packing, is set out under how a coil becomes a packed lot.

Which markets take it

Inspection and documents

What we check, and when

Common questions

What kind of tooling do you build?
Alpine Electrotech builds progressive tooling, including auto-stack and auto-skew, from either tungsten carbide or high-speed steel to suit the part. Tools are built to Alpine's own standards by long-standing, dedicated toolmakers, and are maintained on the same floor that runs them, so a worn tool is sharpened in house on Alpine's own grinders.
How is tooling handled, and how is it paid for?
Alpine Electrotech both builds its own tooling and runs customer-supplied tooling for jobwork; how a tool is handled is agreed per part. Where we build the tool, its cost is amortised transparently in the costing. The tool layout and the tool cost are quoted alongside the part rate, so you see both before you commit.
How long does it take to get samples?
Samples from Alpine Electrotech are typically ready 60-90 days from receipt of the drawing and order confirmation. The part is released to run only after first-off inspection against the agreed tolerances.
What tolerances do you hold?
Alpine Electrotech agrees tolerances per part against your drawing and confirms them at first-off inspection. We do not publish a blanket tolerance, because the figure that matters is the one on your drawing.

Other products

Every product in one list

Request a quotation

What do you need? *
See the E&I chart

Up to 10 MB. .pdf, .dwg, .dxf, .step, .stp, .igs, .iges, .png, .jpg, .jpeg, .zip.

We reply within two working days.

We use what you send only as set out in our Privacy policy