Products
T&U core laminations
Alpine Electrotech makes T and U core laminations for small transformers and chokes in CRGO and CRNO, to your drawing, at its works in Daman, India.
Specification
- Grades
- CRGO, CRNOCRGO: Grain-oriented electrical steel for transformer cores. CRNO: Non-oriented electrical steel for rotating machines.
- Thicknesses
- 0.23 mm to 0.50 mm
- Coatings
- C3, C5
- Sold by
- By weight (kg)
The thicknesses and coatings available for a given part depend on the grade. We confirm availability for your part at enquiry.
How it is made
Coil is slit in house to the width the tool needs, from mother coil up to 1250 mm wide, and the slit edge is checked for burr before the strip is released to the press floor.
Alpine Electrotech stamps on progressive tooling on power presses from 10 T to 220 T. Tools are built from tungsten carbide or high-speed steel to suit the part, and are maintained on the same floor that runs them.
The whole run, from material selection to packing, is set out under how a coil becomes a packed lot.
Which markets take it
- Transformers
E&I laminations, strip laminations, T&U cores and cut-to-length transformer laminations.
- UPS, inverter and solar
Small E&I laminations, T&U cores and reactor laminations.
Inspection and documents
Common questions
- Which grades of electrical steel do you work in?
- Alpine Electrotech works in CRGO, CRNO and CRCA. CRGO is grain-oriented electrical steel for transformer cores, CRNO is non-oriented electrical steel for rotating machines, and CRCA is cold-rolled close-annealed steel for the non-electrical parts of an assembly.
- What tolerances do you hold?
- Alpine Electrotech agrees tolerances per part against your drawing and confirms them at first-off inspection. We do not publish a blanket tolerance, because the figure that matters is the one on your drawing.
- How does a new part start?
- A new part at Alpine Electrotech starts with your drawing, stating the grade, thickness, coating and monthly volume. Alpine then prepares the tool layout and quotes the part rate alongside the tool cost and its amortisation, submits samples against the drawing, agrees tolerances per part and confirms them at first-off inspection, and releases the part to run against your schedule.
- What documents come with a despatch?
- Every despatch from Alpine Electrotech carries the source mill’s test certificate and a finished-goods inspection report, raised per lot. Lot identity is maintained through packing.