Skip to content

Products

Segmental laminations

Alpine Electrotech makes segmental laminations in CRNO for large-diameter cores, where a full ring would waste material, to your drawing at its works in Daman, India.

Specification

Grades
CRNOCRNO: Non-oriented electrical steel for rotating machines.
Thicknesses
0.35 mm to 0.65 mm
Coatings
C3, C5, C6
Sold by
By the piece

The thicknesses and coatings available for a given part depend on the grade. We confirm availability for your part at enquiry.

How it is made

Coil is slit in house to the width the tool needs, from mother coil up to 1250 mm wide, and the slit edge is checked for burr before the strip is released to the press floor.

Alpine Electrotech stamps on progressive tooling on power presses from 10 T to 220 T. Tools are built from tungsten carbide or high-speed steel to suit the part, and are maintained on the same floor that runs them.

The whole run, from material selection to packing, is set out under how a coil becomes a packed lot.

Which markets take it

Inspection and documents

What we check, and when

Common questions

Which grades of electrical steel do you work in?
Alpine Electrotech works in CRGO, CRNO and CRCA. CRGO is grain-oriented electrical steel for transformer cores, CRNO is non-oriented electrical steel for rotating machines, and CRCA is cold-rolled close-annealed steel for the non-electrical parts of an assembly.
What tolerances do you hold?
Alpine Electrotech agrees tolerances per part against your drawing and confirms them at first-off inspection. We do not publish a blanket tolerance, because the figure that matters is the one on your drawing.
How does a new part start?
A new part at Alpine Electrotech starts with your drawing, stating the grade, thickness, coating and monthly volume. Alpine then prepares the tool layout and quotes the part rate alongside the tool cost and its amortisation, submits samples against the drawing, agrees tolerances per part and confirms them at first-off inspection, and releases the part to run against your schedule.
What documents come with a despatch?
Every despatch from Alpine Electrotech carries the source mill’s test certificate and a finished-goods inspection report, raised per lot. Lot identity is maintained through packing.

Other products

Every product in one list

Request a quotation

What do you need? *
See the E&I chart

Up to 10 MB. .pdf, .dwg, .dxf, .step, .stp, .igs, .iges, .png, .jpg, .jpeg, .zip.

We reply within two working days.

We use what you send only as set out in our Privacy policy